CPC5601D データシートの表示（PDF） - IXYS CORPORATION

部品番号

コンポーネント説明

メーカー

CPC5601D

LITELINK™ Family Auxiliary Programmable Driver IC

IXYS CORPORATION 

INTEGRATED CIRCUITS DIVISION

CPC5601

3.2 Programming Protocol

Figure 5. Latch Circuit Timing to Turn an Output On

INPUT (pin 3)

t0

>=50s (tsetup)

CLOCK

200s

140s

thold

Transition after setup time

initiates clock pulse

B1 (pin 13)

B1 output FET (drain open)

First

reads data

at the rising edge of the clock

A setup pulse on the input of at least 50 S starts the

bit programming sequence. The trailing edge of the

setup pulse starts a timer on the CPC5601 (t0). After

140 S, the value of the input is latched into the shift

register.

B1 output FET on (sinking current)

To set an output, hold the input high for 200 S from

the leading edge after the setup pulse. This turns on

the corresponding open-drain FET to sink current.

Figure 6. Latch Circuit Timing to Turn an Output Off

t0

>=50 s (tsetup)

140 s

50 s

INPUT (pin 3)

150 s min

CLOCK

Transition after setup time

initiates clock pulse

First

reads data

at the rising edge of the clock

B1 (pin 13)

B1 output FET on (sinking current)

B1 output FET (drain open)

To clear an output, hold the input high for 50 S after

the setup pulse, then take the input low for at least 150

S.

Repeat the sequence of the setup pulse followed by

the appropriate input condition for each successive bit.

Bear the following in mind while programming the

CPC5601:

• All bits must be set in each programming sequence,

even to change just one of the outputs.

• Data is placed in least-significant bit (output 1) first.

• After setting all the bits, take the input low. In the

absence of low-to-high transitions on the input, the

internal CPC5601 clock is held high, preventing any

output changes.

• The CPC5601 does not employ a shift register load

function. As new data is shifted into the flip-flops, the

outputs (starting with b1) change throughout the

data input sequence.

3.3 Programming Example

This programming example sets the following

CPC5601 output state, suitable for a European DAA:

R04

www.ixysic.com

11

Share Link: