LTC1728(Old_V) データシートの表示（PDF） - Linear Technology
部品番号
コンポーネント説明
メーカー
LTC1728
(Rev.:Old_V)
(Rev.:Old_V)
Linear Technology
LTC1728 Datasheet PDF : 16 Pages
| |||
LTC1727/LTC1728
APPLICATIO S I FOR ATIO
Override Functions (5V Versions Only)
The VCCA pin, if unused, can be tied to either VCC3 or VCC5.
This is an obvious solution since the trip points for VCC3
and VCC5 will always be greater than the trip point for VCCA.
The VCC5 input trip point is disabled if its voltage is equal
to the voltage on VCC3 ±25mV and the voltage on VCC5 is
less than 4.15V. In this manner, the LTC1727-5/
LTC1728-5 will behave as a 3.3V monitor and VCC5 reset
capability will be disabled.
The VCC5 trip point is reenabled when the voltage on VCC5
is equal to the voltage on VCC3 ±25mV and the two inputs
are greater than approximately 4.15V. In this manner, the
part can function as a 5V monitor with the 3.3V monitor
disabled.
When monitoring either 3.3V or 5V with VCC3 strapped to
VCC5 (see Figure 2), the part determines which is the
appropriate range. The part handles this situation as
shown in Figure 3. Above 1V and below VRT3, RST is held
low. From VRT3 to approximately 4.15V the part assumes
3.3V supply monitoring and RST is deasserted. Above
approximately 4.15V the part operates as a 5V monitor.
In most systems the 5V supply will pass through the 3.1V
to 4.15V region in < 200ms during power-up, and the
RST output will behave as desired. Table 1 summarizes
the state of RST at various operating voltages with
VCC3 = VCC5.
Table 1. Override Truth Table (VCC3 = VCC5)
INPUTS (VCC3 = VCC5 = VCC)
RST
0V ≤ VCC ≤ 1V
—
1V ≤ VCC ≤ VRT3
0
VRT3 ≤ VCC ≤ 4.15V
1
4.15V ≤ VCC ≤ VRT5
0
VRT5 ≤ VCC
1
VCC
3.3V OR 5V
LTC1728-5
5
VCC3
4
VCC5
3
VCCA
1
RST
2
GND
R1
10k
TO SYSTEM
RESET
1727/28 F02
Figure 2. Single Supply Monitor with Others Disabled
5
VCC3 = VCC5 = VCCA = 0V TO 5V
10k PULL-UP FROM RST TO VCC3
4
3
2
1
0
0
1
2
3
4
5
SUPPLY VOLTAGE (V)
1727/28 F03
Figure 3. RST Voltage vs Supply Voltage
10
Share Link: