UPB1509GV-E1 データシートの表示（PDF） - California Eastern Laboratories.
部品番号
コンポーネント説明
メーカー
UPB1509GV-E1 Datasheet PDF : 8 Pages
| |||
ABSOLUTE MAXIMUM RATINGS1 (TA = 25°C)
SYMBOLS PARAMETERS
UNITS
RATINGS
VCC1, VCC2 Supply Voltage
V
VIN
Input Voltage
V
PD
Power Dissipation2
mW
TOP Operating Temperature °C
TSTG Storage Temperature
°C
6.0
6.0
250
-45 to +85
-55 to +150
Notes:
1. Operation in excess of any one of these parameters may result
in permanent damage.
2. Mounted on a double-sided copper clad 50x50x1.6 mm epoxy
glass PWB (TA = +85˚C).
UPB1509GV
RECOMMENDED
OPERATING CONDITIONS
SYMBOL
PARAMETER
VCC1, VCC2 Supply Voltage
TOP Operating Temperature
UNITS MIN TYP MAX
V 2.2 3.0 5.5
°C -40 +25 +85
INTERNAL BLOCK DIAGRAM
IN
DQ
DQ
DQ
IN
CLK
CLK
CLK
Q
Q
Q
OUT
SW1
SW2
PIN DESCRIPTIONS
Pin No.
Symbol
1
VCC1
2
IN
3
IN
4
GND
5
SW1
6
SW2
7
OUT
8
VCC2
Applied
Voltage
2.2 to 5.5
–
–
0
H/L
(VCC/OPEN)
H/L
(VCC/OPEN)
–
2.2 to 5.5
Pin
Voltage
–
1.7 to 4.95
1.7 to 4.95
–
–
1.0 to 4.7
–
Description
Power supply pin of input amplifier and dividers. This pin must be
equipped with bypass capacitor (eg 1000 pF) to ground.
Signal input pin. This pin should be coupled with a capacitor (eg 1000 pF).
Signal input bypass pin. This pin must be equipped with a bypass
capacitor (eg 1000 pF) to ground.
Ground pin. Ground pattern on the board should be formed as wide as
possible to minimize ground impedance.
Divided ratio control pin. Divide ratio can be controlled by the following
input voltages to these pins.
SW1
H (VCC)
L (OPEN)
H (VCC)
1/2
SW2
L (OPEN)
1/4
1/4
1/8
These pins must each be equipped with a bypass capacitor to ground.
Divided frequency output pin. This pin is designed as an emitter follower
output. This pin can output 0.1 Vp-p min with a 200 Ω load.
This pin should be coupled to load device with a capacitor (eg 1000 pF).
Power supply pin of output buffer amplifier. This pin must be equipped
with bypass capacitor (eg 1000 pF) to ground.
Share Link: 