MAX32 データシートの表示（PDF） - Unspecified

部品番号

コンポーネント説明

メーカー

MAX32

Max32™ Board Reference Manual

Unspecified 

Max32™ Board Reference Manual

1 Max32 Hardware Overview

The Max32 board has the following hardware features:

1. USB Connector for USB Serial Converter

This connects to a USB port on the PC to provide the communications port for the MPIDE to talk to

the Max32 board. This can also be used to power the Max32 board when connected to the PC.

2. J11: Microchip Debug Tool Connector

This connector is used to connect Microchip programmer/debugger tools, such as the PICkit™ 3, for

in-circuit serial programming (ICSP). This allows the Max32 board to be used as a traditional

microcontroller development board using the Microchip MPLAB® IDE.

3. J2: External Power Connector

This is used to power the Max32 board from an external power supply. This is a 5.5mm x 2.1mm

barrel connector. It is wired with the center terminal as the positive supply voltage. The power supply

voltage must be in the range of 7V to 15V.

4. Power Supply – 3.3V Regulator

Voltage regulator for the 3.3V power supply. This power supply can provide up to 500mA of current.

5. JP1: Power Select Jumper

This jumper is used to route power from the external power connector through the on-board 5V

voltage regulator or to bypass the 5V regulator. The REG position routes power through the 5V

regulator. The BYP position bypasses the on-board 5V regulator. With this jumper in the BYP position,

the maximum input voltage that can be applied at the external power connector is 6V.

6. Power Supply – 5V Regulator

Copyright Digilent, Inc. All rights reserved.

Other product and company names mentioned may be trademarks of their respective owners.

Page 2 of 20

Share Link: