PMC
Pm25LV010/020/040
DEVICE OPERATION (CONTINUED)
READ PRODUCT IDENTIFICATION BY JEDEC ID
COMMAND
The JEDEC ID READ instruction allows the user to read
the manufacturer and product ID of the devices. Refer to
Table 9 Product Identification for PMC manufacturer ID
and device ID. The second manufacturer ID (7Fh) is
shifted out on SO with the MSB first after JEDEC ID
READ command input, followed by the first manufac-
turer ID (9Dh) and the device ID, each bit been shifted
out during the falling edge of SCK.
If the CE# stays low after the last bit of device ID is
shifted out, the manufacturer ID and device ID will be loop-
ing until the pulled high of CE# signal.
Figure 4. Read Product Identification by JEDEC ID READ Sequence
CE#
SCK
SI
0
78
INSTRUCTION
1001 1111b
15 16
23 24
31
SO
HIGH IMPEDANCE
Manufacture ID2
Manufacture ID1
Device ID
Programmable Microelectronics Corp.
12
Issue Date: July, 2005, Rev: 1.2