MAX5250 データシートの表示（PDF） - Maxim Integrated

部品番号

コンポーネント説明

メーカー

MAX5250

Low-Power, Quad, 10-Bit Voltage-Output DAC with Serial Interface

Maxim Integrated 

Low-Power, Quad, 10-Bit Voltage-Output DAC

with Serial Interface

CS

SCLK

DIN

DOUT

(MODE 0)

DOUT

(MODE 1)

COMMAND

EXECUTED

1

8

9

16

A1

A0 C1 C0 D9 D8 D7 D6 D5

D4 D3 D2 D1 D0 S1 S0

DATA PACKET (N)

A1

A0 C1 C0 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0 S1 S0 A1

MSB FROM

PREVIOUS WRITE

DATA PACKET (N-1)

DATA PACKET (N)

A1 A0 C1 C0 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0 S1 S0 A1

MSB FROM

PREVIOUS WRITE

DATA PACKET (N-1)

DATA PACKET (N)

Figure 5. Serial-Interface Timing Diagram

CS

SCLK

DIN

DOUT

tCSO

tCSS

tDS tDH

tCH

tCL

tCSW

tCP

tCSH

tCS1

tDO1 tDO2

Figure 6. Detailed Serial-Interface Timing Diagram

Power-Down (PDL)

The power-down lockout pin PDL disables software

shutdown when low. When in shutdown, transitioning

PDL from high to low wakes up the part with the output

set to the state prior to shutdown. PDL can also be

used to wake up the device asynchronously.

Daisy Chaining Devices

Any number of MAX5250s can be daisy chained by

connecting the DOUT pin of one device to the DIN pin

of the following device in the chain (Figure 7).

Since the MAX5250’s DOUT pin has an internal active

pull-up, the DOUT sink/source capability determines

the time required to discharge/charge a capacitive

load. Refer to the serial-data-out VOH and VOL specifi-

cations in the Electrical Characteristics.

Figure 8 shows an alternate method of connecting sev-

eral MAX5250s. In this configuration, the data bus is

common to all devices; data is not shifted through a

daisy chain. More I/O lines are required in this configu-

ration because a dedicated chip-select input (CS) is

required for each IC.

______________________________________________________________________________________ 11

Share Link: