KSZ9031RNX(2012) データシートの表示（PDF） - Micrel

部品番号

コンポーネント説明

メーカー

KSZ9031RNX
(Rev.:2012)

Gigabit Ethernet Transceiver with RGMII Support

Micrel 

Micrel, Inc.

KSZ9031RNX

Auto MDI/MDI-X is enabled by default. It is disabled by writing a one to register 1Ch, bit [6]. MDI and MDI-X mode is set

by register 1Ch, bit [7] if Auto MDI/MDI-X is disabled.

An isolation transformer with symmetrical transmit and receive data paths is recommended to support Auto MDI/MDI-X.

Pair-Swap, Alignment, and Polarity Check

In 1000Base-T mode, the KSZ9031RNX

• Detects incorrect channel order and automatically restores the pair order for the A, B, C, D pairs (four channels)

• Supports 50±10ns difference in propagation delay between pairs of channels in accordance with the IEEE 802.3

standard, and automatically corrects the data skew so the corrected four pairs of data symbols are synchronized

Incorrect pair polarities of the differential signals are automatically corrected for all speeds.

Wave Shaping, Slew-Rate Control, and Partial Response

In communication systems, signal transmission encoding methods are used to provide the noise-shaping feature and to

minimize distortion and error in the transmission channel.

• For 1000Base-T, a special partial-response signaling method is used to provide the band-limiting feature for the

transmission path.

• For 100Base-TX, a simple slew-rate control method is used to minimize EMI.

• For 10Base-T, pre-emphasis is used to extend the signal quality through the cable.

PLL Clock Synthesizer

The KSZ9031RNX generates 125MHz, 25MHz, and 10MHz clocks for system timing. Internal clocks are generated from

the external 25MHz crystal or reference clock.

Auto-Negotiation

The KSZ9031RNX conforms to the auto-negotiation protocol, defined in Clause 28 of the IEEE 802.3 Specification.

Auto-negotiation allows UTP (unshielded twisted pair) link partners to select the highest common mode of operation.

During auto-negotiation, link partners advertise capabilities across the UTP link to each other, and then compare their own

capabilities with those they received from their link partners. The highest speed and duplex setting that is common to the

two link partners is selected as the operating mode.

The following list shows the speed and duplex operation mode from highest to lowest.

• Priority 1: 1000Base-T, full-duplex

• Priority 2: 1000Base-T, half-duplex

• Priority 3: 100Base-TX, full-duplex

• Priority 4: 100Base-TX, half-duplex

• Priority 5: 10Base-T, full-duplex

• Priority 6: 10Base-T, half-duplex

If auto-negotiation is not supported or the KSZ9031RNX link partner is forced to bypass auto-negotiation for 10Base-T

and 100Base-TX modes, the KSZ9031RNX sets its operating mode by observing the input signal at its receiver. This is

known as parallel detection, and allows the KSZ9031RNX to establish a link by listening for a fixed signal protocol in the

absence of the auto-negotiation advertisement protocol.

The auto-negotiation link-up process is shown in Figure 3.

October 2012

20

M9999-103112-1.0

Share Link: