A42MX36-PG100A データシートの表示（PDF） - Microsemi Corporation

部品番号

コンポーネント説明

メーカー

A42MX36-PG100A

40MX and 42MX FPGA

Microsemi Corporation 

40MX and 42MX FPGAs

3.2.3.3

Figure 7 •

Antifuse Structures

An antifuse is a “normally open” structure. The use of antifuses to implement a programmable logic

device results in highly testable structures as well as efficient programming algorithms. There are no

pre-existing connections; temporary connections can be made using pass transistors. These temporary

connections can isolate individual antifuses to be programmed and individual circuit structures to be

tested, which can be done before and after programming. For instance, all metal tracks can be tested for

continuity and shorts between adjacent tracks, and the functionality of all logic modules can be verified.

MX Routing Structure

Segmented

Horizontal

Routing

Logic

Modules

Antifuses

3.2.4

Vertical Routing Tracks

Clock Networks

The 40MX devices have one global clock distribution network (CLK). A signal can be put on the CLK

network by being routed through the CLKBUF buffer.

In 42MX devices, there are two low-skew, high-fanout clock distribution networks, referred to as CLKA

and CLKB. Each network has a clock module (CLKMOD) that can select the source of the clock signal

from any of the following (Figure 8, page 13):

• Externally from the CLKA pad, using CLKBUF buffer

• Externally from the CLKB pad, using CLKBUF buffer

• Internally from the CLKINTA input, using CLKINT buffer

• Internally from the CLKINTB input, using CLKINT buffer

The clock modules are located in the top row of I/O modules. Clock drivers and a dedicated horizontal

clock track are located in each horizontal routing channel.

Clock input pads in both 40MX and 42MX devices can also be used as normal I/Os, bypassing the clock

networks.

The A42MX36 device has four additional register control resources, called quadrant clock networks

(Figure 9, page 13). Each quadrant clock provides a local, high-fanout resource to the contiguous logic

modules within its quadrant of the device. Quadrant clock signals can originate from specific I/O pins or

from the internal array and can be used as a secondary register clock, register clear, or output enable.

DS2316 Datasheet Revision 16.0

12

Share Link: