28F256L30 データシートの表示（PDF） - Numonyx -> Micron

部品番号

コンポーネント説明

メーカー

28F256L30

Numonyx™ StrataFlash® Wireless Memory(L30)

Numonyx -> Micron 

Numonyx™ StrataFlash® Wireless Memory (L30)

5.0

Maximum Ratings and Operating Conditions

5.1

Warning:

Absolute Maximum Ratings

Stressing the device beyond the “Absolute Maximum Ratings” may cause permanent

damage. These are stress ratings only. Operation beyond the “Operating Conditions” is

not recommended and extended exposure beyond the “Operating Conditions” may

affect device reliability.

Table 7: Absolute Maximum Ratings Table

Parameter

Maximum Rating

Notes

Temperature under bias

–25 °C to +85 °C

Storage temperature

–65 °C to +125 °C

Voltage on any signal (except VCC, VPP)

VPP voltage

–0.5 V to +3.8 V

–0.2 V to +10 V

1

1,2,3

VCC voltage

–0.2 V to +2.5 V

1

VCCQ voltage

–0.2 V to +3.8 V

1

Output short circuit current

100 mA

4

Notes:

1.

Voltages shown are specified with respect to VSS. Minimum DC voltage is –0.5 V on input/output signals and –0.2 V on

VCC, VCCQ, and VPP. During transitions, this level may undershoot to –2.0 V for periods < 20 ns. Maximum DC voltage on

VCC is VCC +0.5 V, which, during transitions, may overshoot to VCC +2.0 V for periods < 20 ns. Maximum DC voltage on

input/output signals and VCCQ is VCCQ +0.5 V, which, during transitions, may overshoot to VCCQ +2.0 V for periods < 20

ns.

2.

Maximum DC voltage on VPP may overshoot to +14.0 V for periods < 20 ns.

3.

Program/erase voltage is typically 1.7 V – 2.0 V. 9.0 V can be applied for 80 hours maximum total, to main blocks for

1000 cycles maximum and to parameter blocks for 2500 cycles maximum. 9.0 V program/erase voltage may reduce

block cycling capability.

4.

Output shorted for no more than one second. No more than one output shorted at a time.

5.2

Operating Conditions

Table 8: Operating Conditions Table

Symbol

Parameter

Min

Max

Units

Notes

TC

Operating Temperature

–25

+85

°C

1

VCC

VCC Supply Voltage

1.7

2.0

VCCQ

VPPL

I/O Supply Voltage

VPP Voltage Supply (Logic Level)

2.2

3.3

V

0.9

3.3

VPPH

Factory word programming VPP

8.5

9.5

tPPH

Block

Erase

Cycles

Maximum VPP Hours

Main and Parameter Blocks

Main Blocks

Parameter Blocks

VPP = VPPH

VPP = VCC

VPP = VPPH

VPP = VPPH

-

80

Hours

2

100,000

-

-

1000

Cycles

-

2500

Notes:

1.

TC = Case Temperature

2.

In typical operation, the VPP program voltage is VPPL. VPP can be connected to 8.5 V – 9.5 V for 1000 cycles on main

blocks and 2500 cycles on parameter blocks.

Datasheet

22

November 2007

Order Number: 251903-11

Share Link: