NAND04GW3C2N1E データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

NAND04GW3C2N1E

4Gbit, 2112 Byte Page, 3V, Multi-level NAND Flash Memory

STMicroelectronics 

NAND04GA3C2A, NAND04GW3C2A

4

Bus operations

4 Bus operations

There are six standard bus operations that control the memory. Each of these is described

in this section, see Table 5: Bus Operations, for a summary.

Typically, glitches of less than 5 ns on Chip Enable, Write Enable and Read Enable are

ignored by the memory and do not affect bus operations.

4.1

Command Input

Command Input bus operations are used to give commands to the memory. Commands are

accepted when Chip Enable is Low, Command Latch Enable is High, Address Latch Enable

is Low and Read Enable is High. They are latched on the rising edge of the Write Enable

signal.

Only I/O0 to I/O7 are used to input commands.

See Figure 13 and Table 19 for details of the timings requirements.

4.2

Address Input

Address Input bus operations are used to input the memory addresses. Five bus cycles are

required to input the addresses (refer to Table 6: Address insertion).

The addresses are accepted when Chip Enable is Low, Address Latch Enable is High,

Command Latch Enable is Low and Read Enable is High. They are latched on the rising

edge of the Write Enable signal. Only I/O0 to I/O7 are used to input addresses.

See Figure 14 and Table 19 for details of the timings requirements.

4.3

Data Input

Data Input bus operations are used to input the data to be programmed.

Data is only accepted when Chip Enable is Low, Address Latch Enable is Low, Command

Latch Enable is Low and Read Enable is High. The data is latched on the rising edge of the

Write Enable signal. The data is input sequentially using the Write Enable signal.

See Figure 15 and Table 19 for details of the timing requirements.

4.4

Data Output

Data Output Bus operations are used to read: the data in the memory array, the Status

Register, the Electronic Signature and the Unique Identifier.

Data is output when Chip Enable is Low, Write Enable is High, Address Latch Enable is Low,

and Command Latch Enable is Low.

The data is output sequentially using the Read Enable signal.

See Figure 16 and Table 20 for details of the timings requirements.

15/51

Share Link: