CS61583 データシートの表示（PDF） - Cirrus Logic
部品番号
コンポーネント説明
メーカー
CS61583 Datasheet PDF : 44 Pages
| |||
CS61583
NORMALIZED
AMPLITUDE
1.0
0.5
ANSI T1.102
SPECIFICATION
Percent of
nominal
peak
voltage
120
110
100
90
80
269 ns
244 ns
194 ns
G.703
Specification
0
CS61583
OUTPUT
PULSE SHAPE
-0.5
0
250
500
750
TIME (nanoseconds)
1000
Figure 6. Typical Pulse Shape at DSX-1 Cross Connect
during the transmission of both marks and
spaces. This improves signal quality by minimiz-
ing reflections from the transmitter. Impedance
matching also reduces load power consumption
by a factor of two when compared to the return
loss achieved by using external resistors.
The CS61583 driver will automatically detect an
inactive TLCK input (i.e., no valid data is being
clocked to the driver). When this condition is de-
tected, the driver is forced low (except during
remote loopback) to output spaces and prevent
TTIP and TRING from entering a constant trans-
mit-mark state.
50
10
0
-10
-20
219 ns
488 ns
Nominal Pulse
Figure 7. Pulse Mask at the 2048 kbps Interface
When any transmit configuration established by
CON[2:0], TAOS, or LLOOP changed states, the
transmitter stabilizes within 22 TCLK bit peri-
ods. The transmitter takes longer to stabilize
when RLOOP1 or RLOOP2 is selected because
the timing circuitry must adjust to the new fre-
quency from RCLK.
When the transmitter transformer secondaries are
shorted through a 0.5 ohm resistor, the transmit-
C C C Transmit Pulse
O O O Width at 50% Transmit Pulse Shape
NNN
Amplitude
210
Receiver
Slicing
Level
0 0 0 244 ns (50%) E1: square, 2.37 Volts into 75 Ω
0 0 1 244 ns (50%) E1: square, 3.00 Volts into 120 Ω
50%
50%
0 1 0 350 ns (54%) DSX-1: 0-133 ft. / or DS1 FCC Part 68 Option A with undershoot 65%
0 1 1 350 ns (54%) DSX-1: 133-266 ft.
65%
1 0 0 350 ns (54%) DSX-1: 266-399 ft.
65%
1 0 1 350 ns (54%) DSX-1: 399-533 ft.
65%
1 1 0 350 ns (54%) DSX-1: 533-655 ft.
65%
1 1 1 324 ns (50%) DS1: FCC Part 68 Option A (0 dB)
65%
Table 1. Configuration Selection
DS172PP5
11
Share Link: 